Floor Buffer Concrete Finishing Tool 15 Inch Block Fits Most 17 or 18 Inch Floor Buffers Using Universal Clutch Plate 364192N Carlisle 361500GA 192N

CARLISLE - Master Craftsmen In Brush Making!

Concrete Finishing Tool, Fits Most 17 or 18 Inch Floor Buffers Using Universal Clutch Plate 364192N, Carlisle 361500GA-192N.

Grind-Away Concrete Smoothing, Finishing Tool For Concrete Floors.

• For Smoothing and Finishing After Concrete Patchwork.
• Designed to fit 17 or 18 Inch machines, this 15 Inch Disk Block is equipped with 3 replaceable silicon carbide grit blocks; three replacement grit blocks per set.
• The Universal Clutch Plate (attaches disk block to machine) is a 364192N Heavy Duty Metal standard 5 inch center hole size fitting many machines, including Kent, Pullman Holt, Oreck, Advance, Alto, Clarke, Betco, Cassidy, Dart, Eureka, General, Hawk, Hoover, Koblenz, Lawlor, Mastercraft, Mercury, NSS, Nilfisk, Pacific, SSS, Thoromatic, Tornado, United, Viper.
• Grind-Away can be fit with Scrape-Away cutting hardware as well.
• Note: Do not use with flammable materials (fuels, solvents, thinner, etc.) as serious bodily harm or injury could result from possible fire or explosion.

Special Factory Direct Shipping Charge Of $29.95 Delivers Your New Scrape-Away To Your Door!

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerSerivice@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type.