Floor Buffer Scrub Brush For Kent KA261B Auto Scrubber, Requires Two Brushes, Grey .018 Nylon 500 Grit 13 Inch Block, Malish 813313-L801P

MALISH - The World's Premier Brush Maker!!

Floor Buffer Scrub Brush For Kent KA261B Auto Scrubber, Requires Two Brushes, Grey .018 Nylon 500 Grit 13 Inch Block, Malish 813313-L801P.

A Grey Nylon filament with Silicon Carbide Grit used for medium scrubbing of vinyl, sealed concrete, terrazzo, slate, and marble floors.

• Mal-Grit Lite Brush for medium scrubbing of vinyl, sealed concrete, terrazzo, slate, marble floors, and non-slip epoxy finishes.
• Designed to fit Kent KA261B Auto Scrubber, Requires Two Brushes.
• The L801 Clutch Plate (attaches brush block to machine) is a 3 lug design, with a 1 7/8 inch center hole size.
• Grey Colored .018 inch DuPont Tynex A Nylon fibers impregnated with 500 grit silicon carbide.
• Replaces Red Pads.
• Note: Do not use brush with flammable materials (fuels, solvents, thinner, etc.) as serious bodily harm or injury could result from possible fire or explosion.

Special Factory Direct Shipping Charge Of $9.95 Delivers Your New Rotary Brush To Your Door!

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerSerivice@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type.