Floor Buffer Pad Holder 1/2 Inch Short Trim With Clutch Plate and Riser 13 Inch Block Fits Most 14 Inch Floor Buffers Using Universal Clutch Plate 364192P Riser 361726S Carlisle 361300PDS 726S 192P

CARLISLE - Master Craftsmen In Brush Making!

Floor Buffer Pad Holder 1/2 Inch Short Trim With Clutch Plate and Riser Fits Most 14 Inch Floor Buffers Using Universal Clutch Plate 364192P Riser 361726S Carlisle 361300PDS-726S-192P.

Pad Holders attach to floor buffers and use 1/2 inch stiff brush bristles for holding floor buffer pads onto the bottom of floor buffers.

• Designed to fit 14 Inch machines, this 13 Inch Plastic Block Pad Holder Uses 14 Inch Floor Buffer Pads.
• The Universal Clutch Plate 364192P with 1 7/16 inch plastic riser 361726S (attaches block to machine) is a durable plastic standard 5 inch center hole size fitting many machines, including Kent, Pullman Holt, Oreck, Advance, Alto, Clarke, Betco, Cassidy, Dart, Eureka, General, Hawk, Hoover, Koblenz, Lawlor, Mastercraft, Mercury, NSS, Nilfisk, Pacific, SSS, Sanitaire, Thoromatic, Tornado, United, Viper.

Special Factory Direct Shipping Charge Of $9.95 Delivers Your New Pad Holder To Your Door!

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerSerivice@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type.