Floor Buffer Pad Holder Malish UniBlock 1/2 Inch Short Trim With Clutch Plate and Riser Molded In 19 Inch Block Fits Most 20 Inch Floor Buffers Using Universal Clutch Plate NP9200, Malish, 862719

MALISH - The World's Premier Brush Maker!!

Floor Buffer Pad Holder Malish UniBlock 1/2 Inch Short Trim With Clutch Plate and Riser Molded In 19 Inch Block Fits Most 20 Inch Floor Buffers Using Universal Clutch Plate NP9200, Malish, 862719.

Pad Holders attach to floor buffers and use 1/2 inch stiff brush bristles for holding floor buffer pads onto the bottom of floor buffers.

• Designed to fit 20 Inch machines, this 19 Inch Plastic Block Pad Holder Uses 20 Inch Floor Buffer Pads.
• The Molded In Universal Clutch Plate NP9200 with 1 7/16 inch plastic riser (attaches block to machine) is a durable plastic standard 5 inch center hole size fitting many machines, including Kent, Pullman Holt, Oreck, Advance, Alto, Clarke, Betco, Cassidy, Dart, Eureka, General, Hawk, Hoover, Koblenz, Lawlor, Mastercraft, Mercury, NSS, Nilfisk, Pacific, SSS, Sanitaire, Thoromatic, Tornado, United, Viper.

Special Factory Direct Shipping Charge Of $9.95 Delivers Your New Pad Holder To Your Door!

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerSerivice@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type.