Kent Auto Scrubber Pad Holder With Pad Centering Device Malish Mal Lok One Inch Trim With Clutch Plate 18 Inch Block Fits 20 Inch Kent or Advance Machines Using Clutch Plate 4148PMD, Malish, 782458-2405-4148PMD

MALISH - The World's Premier Brush Maker!!

Kent Auto Scrubber Pad Holder With Pad Centering Device Malish Mal Lok One Inch Trim With Clutch Plate 18 Inch Block Fits 20 Inch Kent or Advance Machines Using Clutch Plate 4148PMD, Malish, 782458-2405-4148PMD.

Pad Holders attach to floor buffers and use stiff one inch brush bristles for holding floor buffer pads onto the bottom of floor buffers. Pad Centering Device locks pad to center for improved performance. Recommended for auto scrubbers or use with carpet bonnets. Showerfeed holes allow use with solution dispensing machines.

• Designed to fit 20 Inch machines, this 18 Inch Plastic Block Pad Holder Uses 20 Inch Floor Buffer Pads.
• The Clutch Plate 4148PMD (attaches block to machine) is a durable plastic standard 5 inch center hole size.

Special Factory Direct Shipping Charge Of $9.95 Delivers Your New Pad Holder To Your Door!

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerSerivice@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type. Plastic face or short trim pad holders are usually recommended at 1 inch smaller than both buffer size and pads to be used, i.e., buffers that use 17 inch pads would use a 16 inch block pad holder.