Floor Buffer Diamond Disc Pad Holder Aluminum Back 17 Inch Block Fits Most 17 Inch or Larger 175 RPM Floor Buffers Using Universal Clutch Plate NP9200 With Riser, Malish, 824017-R150-9200

MALISH - The World's Premier Brush Maker!!

Floor Buffer Diamond Disc Pad Holder Aluminum Back 17 Inch Block Fits Most 17 Inch or Larger 175 RPM Floor Buffers Using Universal Clutch Plate NP9200 With Riser, Malish, 824017-R150-9200.

Pad Holders attach to floor buffers and use molded in hooks for holding diamond abrasive discs or floor buffer pads onto the bottom of floor buffers. Diamond Discs are used for stone, marble, granite or concrete floor maintenance. Since increased floor buffer weight is desired, this extra strong pad holder is specifically designed to both carry the weight and hold Diamond Discs in place.

• Designed to fit 17 Inch or larger machines, this 17 Inch Aluminum Back Pad Holder Uses 18 Inch Floor Buffer Pads.
• The Universal Clutch Plate NP9200 with riser (attaches block to machine) is a durable plastic standard 5 inch center hole size fitting many machines, including Kent, Pullman Holt, Oreck, Advance, Alto, Clarke, Betco, Cassidy, Dart, Eureka, General, Hawk, Hoover, Koblenz, Lawlor, Mastercraft, Mercury, NSS, Nilfisk, Pacific, SSS, Sanitaire, Thoromatic, Tornado, United, Viper.

Special Factory Direct Shipping Charge Of $9.95 Delivers Your New Pad Holder To Your Door!

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerSerivice@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type. Plastic face or short trim pad holders are usually recommended at 1 inch smaller than both buffer size and pads to be used, i.e., buffers that use 17 inch pads would use a 16 inch block pad holder.