Floor Buffer Pad Holder Malish Mal Lok One Inch Trim With 1.75 Inch Center Hole 10 Inch Block Fits Clarke P12 12 Inch Floor Buffers Using Your Old Original Clutch Plate, Malish, 782450-1.75CH

MALISH - The World's Premier Brush Maker!!

Floor Buffer Pad Holder Malish Mal Lok One Inch Trim With 1.75 Inch Center Hole 10 Inch Block Fits Clarke P12 12 Inch Floor Buffers Using Your Old Original Clutch Plate, Malish, 782450-1.75CH.

Pad Holders attach to floor buffers and use stiff one inch brush bristles for holding floor buffer pads onto the bottom of floor buffers. Recommended for auto scrubbers or use with carpet bonnets. Showerfeed holes allow use with solution dispensing machines, 1.75 inch center hole.

• Designed to fit 12 Inch machines, this 10 Inch Plastic Block Pad Holder Uses 12 Inch Floor Buffer Pads.
• By removing your original clutch plate from your old brush or pad holder, fastening it to the new pad holder block, you can use this new pad holder to keep your machine in service.

Special Factory Direct Shipping Charge Of $9.95 Delivers Your New Pad Holder To Your Door!

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerSerivice@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type. Plastic face or short trim pad holders are usually recommended at 1 inch smaller than both buffer size and pads to be used, i.e., buffers that use 17 inch pads would use a 16 inch block pad holder.