Kent Razor Plus Auto Scrubber Pad Holder For 24 Inch Kent Razor Plus, 11 Inch Block, Requires Two Pad Holders, Kent, L08603939

CARLISLE - Master Craftsmen In Brush Making!

Kent Razor Plus Auto Scrubber Pad Holder For 24 Inch Kent Razor Plus, 11 Inch Block, Requires Two Pad Holders, Kent, L08603939.

Pad Holders attach to auto scrubbers and use 1/2 inch stiff brush bristles for holding floor buffer pads onto the bottom of scrubbers.

• Designed to fit Kent Razor Plus Auto Scrubbers 24 Inch machines, this 11 Inch Plastic Block Pad Holder Uses 12 Inch Floor Buffer Pads.
• The Universal Clutch Plate 364148P with 1 7/16 inch plastic riser 361726S (attaches block to machine) is a durable plastic standard 5 inch center hole size.

Special Factory Direct Shipping Cost Of $9.95 Delivers Your New Auto Scrubber Pad Holder To Your Door!

Note: All Equipment Sales Are Final And Covered By Manufacturers Warranty.


NOTE: No Returns On Floor Buffer Brushes. All Brushes Are Custom Made To Fit. If You Are Unsure Of Brush Size or Type, Please Contact Cleaning Stuff Customer Service With Your Floor Buffer Size, Make and Model: By Phone: 1-866-497-2056 (Open: 8am-5pm ET) or Email: CustomerSerivice@CleaningStuff.Net . Most Manufacturers Recommend Brush Blocks (Hard Part) 2 Inches Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 15 Inch Brush Block. Half Inch Trim Pad Holders Require A Brush Block One Inch Smaller Than Buffer Size, i.e., A 17 Inch Buffer Requires A 16 Inch Pad Holder Brush Block. Clutch Plates, Used To Connect Brush Block To Buffer, Vary By Buffer Type.